Installing Lights In Concrete

When dealing with concrete this is not an easy task.

Installing lights in concrete.

Use two work straps and wrap. Cut the rope lights only on the areas. Make sure the wires stay exposed through the top of the post as you work. They offer enough light for safety but the light is subtle enough that it isn t distracting.

Place a clamp every 12 to 24 inches along the. Slide the shaft of the post over the conduit pushing it about 12 inches into the concrete. Put the lamp post down on the ground and pull the wires through working from the bottom to the top. Attach the cable clamps to the rope lights between light bulbs.

If you to try drill into the material you could end up doing more damage than good. Concrete step lights or tread lights fit right into the stairs and focus light downward onto the step immediately below it. How to install rope lights on concrete step 1. Existing concrete ceilings to install recessed lighting into a ceiling a circular shape will need to be cut out and then the lighting installed.

Lay the rope lights against the concrete where you want to install them.